Model Options tab (Drawing View Properties dialog box)

Defines the drawing view options for simplified parts and assembly features.

Simplify

Use simplified parts

Specifies whether simplified parts are shown in a drawing view. You can use this option for drawing views created using a display configuration or a zone.

When the Show Assembly Features box also is checked, both simplified parts and assembly features are displayed in the drawing view.

For all parts

Specifies that simplified parts are used in the drawing view for all parts for which a simplified representation is available.

Note:

Only this option is valid for placement of a drawing view with an assembly zone.

Based on configuration

Specifies that simplified parts are used in the drawing view based on model configuration.

Use simplified assemblies

Specifies whether the simplified assembly representation is used in the drawing view. You can use this option for drawing views created using a display configuration.

For all subassemblies

Specifies that you want the drawing view to display all the subassemblies as simplified for which a simplified representation exists.

Based on configuration

Specifies that you want the drawing view to display the subassemblies as simplified or as designed based on how the configuration you select.

For top assembly

Specifies that you want the drawing view to display only the top level assembly as simplified.

Assembly Features

Show assembly features

Specifies whether assembly features created in the Assembly environment are shown in the drawing view. This option applies only to material removal features such as holes, chamfers, and cutouts. When this box is checked, these types of assembly features are displayed in the drawing view even if the Use Simplified Parts box is also checked.

Note:

You cannot use this option to control the display of assembly material removal or addition features that were applied to pipes, frames, and weld beads.

In these cases, you can only control the display of the entire body using the options on the Display tab on the Drawing View Properties dialog box. For example, if you apply an assembly cutout feature to a pipe, frame, or weld bead, you can only show or hide the entire pipe, frame, or weld bead.

User Interface
Command
Procedure
What are you looking for?
How do I
Look up more details