Return
Returns to the Assembly environment.
Length
Specifies the length of a path segment.
For the start or end point of a path segment, you can click any part or assembly keypoint geometry. You can key in the X, Y, or Z value. If you want to define the start or end point relative to a keypoint, hold the O key down while you click the keypoint. This changes the command bar to display the dx, dy, dz value fields relative to the selected keypoint.
After holding the O key down, you can press the N key to change the orientation of the triad so that dx, dy, dz define a new orientation.
Activate Part
Activates the selected part.
Tip
Displays the Line Segment Tips dialog box that contains tips on using the Line Segment command.